-40%

2015-2020 Optima Sonata Shark Fin Antenna Cover Genuine Kia Moss Gray M5G

$ 15.57

Availability: 11 in stock
  • Fitment Type: Direct Replacement
  • Country/Region of Manufacture: Korea, Republic of
  • Restocking Fee: 20%
  • Manufacturer Part Number: 96219D5000M5GQK
  • Brand: Kia
  • Warranty: 90 Day
  • Item must be returned within: 30 Days
  • Condition: New
  • Interchange Part Number: 96219 D5000M5GQK
  • Antenna Style: Shark Fin Antenna
  • Returns Accepted: Returns Accepted
  • Superseded Part Number: 96219-D5000M5GQK
  • Color: Moss Gray Color Code M5GQK
  • Placement on Vehicle: Roof
  • Refund will be given as: Money Back
  • Return shipping will be paid by: Buyer

    Description

    Brand New in Genuine Kia Box
    Shark Fin Antenna Cover
    / Cover Only
    Factory Pre-painted in Moss Gray Color Code M5G
    Part number 96219-D5000M5GQK
    Fits on
    Kia Optima 2014 through 2020
    Without GPS
    Hyundai Sonata 2015 through 2019
    Without GPS
    Genesis Sedan G80 2015-2016-2017 Without Sunroof
    Genesis Coupe 2013-2014-2015 Without GPS
    Hyundai Elantra Sedan 2011 through 2016
    For antennas that doesn't have a green fin circuit board
    Part is in stock and will be shipped out the same or next day max
    No need to remove the headliner to screw the cover in.
    Loctite 4090 Epoxy or equivalent product is recommended to secure the antenna cover
    Service Procedure:
    1. Carefully separate the antenna cap from the base when broken or loose. Note: If the antenna cover is missing, confirm proper antenna operation. If antenna is operating properly, proceed to step 2.
    2. Remove any remaining plastic remnants from the screws at the antenna base and then using regulated shop air, gently blow and clean the rubber padding of the base.
    3. Using the adhesive kit provided to your dealer, apply a small amount of adhesive over the five screws at the antenna base, enough to cover the screw holes.
    4. Apply a continuous line of adhesive onto the antenna cap channel as outlined in photo, to ensure proper sealing. Do not use too much silicone epoxy or the material may squeeze out during the cover installation.
    5. Carefully align and place the antenna cap over the antenna base. Firmly hold the cap onto the base for fifteen (15) seconds.
    6. Wipe off any excess adhesive and ensure the antenna and surrounding areas are clean.
    7. Remove adhesive tip and discard. Replace the original adhesive cap back onto adhesive tube for future use. Store the tube in a sealed zip-lock bag or container.
    8. Verify proper operation of the radio.